>> Edit article
이름
제목
패스워드
: 노트북 리눅스설치를 할려고 자료를 찾던중 아래 자료를 찾았는데 : : 저의 딸리는 컴터실력과 영어실력으로는 해석이 50%도 불가능 합니다. : : 내용이 이해가 가시거나 해석이 가능 하신분은 리플좀 부탁드립니다 : : __) : Presario 1715 and Linux. January 26th 2002 : : Hardware : : I have an ATI Radeon Mobility M6 LY (....:4c59) with an Intel 830M Agp bridge. I've included the entries at the end of the page. I have also included some of the other important sections. : Settings : Following an install of Slackware 8.0, I compiled the latest kernel and patched it and recompiled it. Currently it's 2.4.17-pre8. I have also had to run the CVS Xfree 4.1.99 which is kinda funny, but works for the most part. : : Video : : This took me the longest to get working as the agpgart module didn't want to load at first. I found out that there are two fixes to this. The second fix (don't use the first one!) is to choose Intel 440LX/BX/GX and I815/I830M/I840/I850 support in the Character Devices section of "make menuconfig" and *not* to select Intel I810/I815/I830 (on-board) support. : : That should get the agpgart loaded nicely. : : **Note** : : I have been reading the changelogs recently. This problem has been fixed by Nicolas Aspert in 2.4.18-pre2. So if you are using it or a later version, you shouldn't have the agpgart problem. : : Now, XF86 4.1.0 doesn't support the Radeon M6 LY so you will likely have to patch it, run a patched distro stock (eg. Red Hat 7.2, Mandrake 8.0 I hear seem to work), or get the cvs version of XF outlined at www.xfree86.org/cvs. : : Upon doing that, in XF86Config, use device "radeon" in the driver section and add the line VideoRam 8192. Also, I think that you won't be able to start up with the framebuffer modes. In lilo.conf, sometimes, you can specify vga=xxx for nice big screens in the console. I don't think this is possible anymore if you run the radeon. I haven't tested it and don't feel like. : : : Sound : This one worked with the Intel 810 driver w/ the kernel. : : : Ethernet : Not yet. : : : ACPI/ APM : This is stupid. There isn't any APM. I'm sure there was a good rea$on for not using APM, but with the poorly supported ACPI, you won't be able to check your batery status as of now. : : Wait for kernel updates. : : lscpi -v is below: : : 00:01.0 PCI bridge: Intel Corporation: Unknown device 3576 (rev 02) (prog-if 00 [Normal decode]) : Flags: bus master, 66Mhz, fast devsel, latency 96 : Bus: primary=00, secondary=01, subordinate=01, sec-latency=64 : I/O behind bridge: 00002000-00002fff : Memory behind bridge: d0100000-d01fffff : Prefetchable memory behind bridge: d8000000-dfffffff : : 00:1f.5 Multimedia audio controller: Intel Corporation: Unknown device 2485 (rev 01) : Subsystem: Compaq Computer Corporation: Unknown device 005c : Flags: bus master, medium devsel, latency 0, IRQ 5 : I/O ports at 1c00 [size=256] : I/O ports at 1880 [size=64] : : 01:00.0 VGA compatible controller: ATI Technologies Inc: Unknown device 4c59 (prog-if 00 [VGA]) : Subsystem: Compaq Computer Corporation: Unknown device b11b : Flags: bus master, stepping, fast Back2Back, 66Mhz, medium devsel, latency 66, IRQ 11 : Memory at d8000000 (32-bit, prefetchable) [size=128M] : I/O ports at 2000 [size=256] : Memory at d0100000 (32-bit, non-prefetchable) [size=64K] : Expansion ROM at <unassigned> [disabled] [size=128K] : Capabilities: <available only to root> : : 02:04.0 Communication controller: CONEXANT: Unknown device 2f00 (rev 01) : Subsystem: Compaq Computer Corporation: Unknown device 8d88 : Flags: medium devsel, IRQ 5 : Memory at d0210000 (32-bit, non-prefetchable) [disabled] [size=64K] : I/O ports at 3040 [disabled] [size=8] : Capabilities: <available only to root> : : 02:08.0 Ethernet controller: Intel Corporation: Unknown device 1031 (rev 41) : Subsystem: Compaq Computer Corporation: Unknown device 0093 : Flags: medium devsel, IRQ 9 : Memory at d0200000 (32-bit, non-prefetchable) [size=4K] : I/O ports at 3000 [size=64] : Capabilities: <available only to root>
Copyleft
1999-2026 by
JSBoard Open Project
Theme Designed by
IDOO
All right reserved